Filter
Top Products
7-9
! Assembly of Inverter PCB (Applicable Model : Digitizer Model)
! Assembly of Touch Screen (Applicable Model : Touch Screen Model)
Conductive Tape
LCD Side Cushion F
LCD Side Cushion E
LCD Side Cushion E
ANT Cable Cushion
Caution High Voltage Label
Inverter Assy
Pay attention to the direction of
the INVERTER PCB when doing
this installation.
LCD Rear Side
Match to the
left end of
the square
hole of the
Connector.
6–2mm from
the branch point
Insert between
the ribs.
Inverter Assy
Connect the Cable to the left
and right Connectors.
Attach so the Inverter Assy
comes at the center.
(Top/Bottom: -2 to +2 mm,
Left/Right: -3 to +3 mm)
0~0.5mm
0~3mm
pasted on the connector
after it is wound around
the cable twice.
Detail of "A"
1~2
mm
Confirm a
"ANT Cable Cushion"
isn’t frayed.
Don’t give stress to LCD TAB.
Insert
Insert
Insert between the ribs.
Insert between the ribs.
0~3mm
0~0.5mm
Avoid any stress on the Cable
when connecting it to the Inverter.
(Hold the Connector part
when connecting/disconnecting.)
Avoid any stress on the Cable
when connecting it to the Inverter.
(Hold the Connector part
when connecting/disconnecting.)
Inverter Assy
LCD Back Dumper
Carefully attach Tape.
Tape
PET Tape2
5~6mm
5~6mm
CCFL Connector side
LCD Cable
Connector side
Wrap over the Antenna Cable
Cushion and the Cable.
Avoid any stress on the TAB
part of the LCD Module.
Wrap.
Safety Working
Safety Working
Avoid getting under the Sheet.
INV Sheet 1
(Black)
Inverter
Case MIL
Inverter
INV Sheet 2(Translucence)
Tape
Sield Sheet
LCD Cable
Insulation Parts
INV MIL Cover
A
Safety Working
TS FPC
Spacer
TS Spacer A
Protect Sheet
LCD Side
Cushion B
Touch
Screen
0~1mm
0~1mm
0~1mm0~1mm
Attach the surface
at the center of
the display.
(Using the jig)
6–0.5mm
0~0.5mm
Dimensional tolerance
:–0.2
A
Detail of "A"
Touch Screen Assy
Touch Screen Assy
TS Spacer A / TS Spacer B:
Don’t get into a LCD indication range.
Be free of overhang..
Attach the surface to the LCD Front.
0~0.5mm
Place this to the wall of cabinet.
–0.5mm
Fit this to the
line of cabinet.
–0.5mm
Fit this to the
line of cabinet.
Back side
OK
Laminate film
Laminate film
Touch Sreen
Touch Sreen
Remove it parallel to the Touch Screen.
NG
TS Spacer B TS Spacer B
TS Spacer A