Filter
Top Products
38 ♦ Advanced Features
Paging
If your system has paging equipment, you can use it to make
announcements to one or more areas or “zones.”
Use the Paging Zones table in the Reference section to record the
location of the paging zones.
To make a page
The Source and Destination areas of your screen must be clear.
1. Press Pager.
If you have only one paging zone, you will be immediately
connected to the pager.
2. Make your announcement.
If you have more than one paging zone
• After pressing Pager, dial the 2-digit Paging Zone Code—(01-
15) or 00 for all zones.
Listen for a long beep. Once you are connected to the paging
circuit, one of these messages appears on your screen:
‘Page Zone Busy’ — someone else is accessing the paging
equipment. Try again later, or press [Override] (if this is
allowed in either your or the paging unit’s Class of Service) to
interrupt the page in progress.
‘Page Zone Unassigned’ — you do not have access to that
paging zone.
‘Connected to Pager’ — you are connected and can make your
announcement.
To end a page
• Press Cancel or Release.
You are disconnected from the paging equipment.