Filter
Top Products
313
CHAPTER 7 PROGRAMMING
7
7.2 When Using the Module in a Standard System Configuration
7.2.1 Standard control (such as auto tuning, self-tuning, and error code read)
(c) Auto refresh setting
Set the device to be automatically refreshed.
Project window [Intelligent Function Module] [Q64TCTTN] [Auto_Refresh]
Remark
The number of parameters of the auto refresh setting can be reduced by using the setting item reduction mode of auto
refresh.
When the setting item reduction mode is set, consecutive devices are automatically set to the grouped setting items.
For details on the setting item reduction mode of auto refresh, refer to the following.
Page 303, Section 6.4
Item Description
Set value
CH1 CH2 CH3 CH4
Write data error code
An error code or alarm code is
stored.
D50
Temperature
process value (PV)
The detected temperature
value where sensor correction
was performed is stored.
D51
Alert definition
The value is stored depending
on the detected alert.
D55