Filter
Top Products
404
Appendix 5.4 Online module change procedures
This section describes two online module change procedures: setting parameters using GX Works2 and the setting
parameters using a sequence program.
(1) System configuration
The following system configuration is used to explain the online module change procedure.
(2) Procedure
The following flow shows the online module change procedure.
16 empty points
QCPU
Q64TCTTN (X/Y10 to X/Y1F)
Start
Mount a new module.
Check the operation.
Restart the control.
End
Stop the operation.
Remove the module.
When parameters are set on GX Works2
When parameters are set on the sequence program
When parameters are set on GX Works2
When parameters are set on the sequence program
When parameters are set on GX Works2
When parameters are set on the sequence program
When parameters are set on GX Works2
When parameters are set on the sequence program
When parameters are set on GX Works2
When parameters are set on the sequence program
Page 405, Appendix 5.5 (1)
Page 406, Appendix 5.5 (2)
Page 407, Appendix 5.5 (3)
Page 407, Appendix 5.5 (4)
Page 409, Appendix 5.5 (5)
Page 410, Appendix 5.6 (1)
Page 411, Appendix 5.6 (2)
Page 412, Appendix 5.6 (3)
Page 412, Appendix 5.6 (4)
Page 415, Appendix 5.6 (5)