Filter
Top Products
350
5. Display the Q64TCTTN auto refresh setting window and configure the setting as follows.
Project window [Intelligent Function Module] [Q64TCTTN] Right-click [Auto_Refresh]
Remark
The number of parameters of the auto refresh setting can be reduced by using the setting item reduction mode of auto
refresh.
When the setting item reduction mode is set, consecutive devices are automatically set to the grouped setting items.
For details on the setting item reduction mode of auto refresh, refer to the following.
Page 303, Section 6.4
6. Write the set parameter to the remote I/O module and reset the remote I/O module.
[Online] [Write to PLC...]
Item Description
Set value
CH1 CH2 CH3 CH4
Write data error code
An error code or alarm code is
stored.
W1150
Temperature
process value (PV)
Detected temperature value
where Sensor Compensation is
performed is stored.
W1151
Alert definition
The value is stored depending
on the detected alert.
W1155
MODE
RESET
Press the switch
for a while.