Filter
Top Products
3. Utilities
34 R100 Wireless Gateway
Chapter 3 - Software Configuration
AP Mode
AP (Access Point) Mode configures the R100 Wireless Gateway for a
specific application. By default, the R100 is configured as an Access
Point which enables wireless mobile clients to connect to a wired
Ethernet network. The following options are available from the drop-
down list:
AP Only: the R100 Wireless Gateway acts only as an Access
Point.
WDS Only: the R100 Wireless Gateway can only communicate
with other Access Points.
Hybrid: Hybrid allows you to use the R100 Wireless Gateway
both as an access point and as a wireless bridge.
Channel
Both Access Points in Wireless Bridge mode must be set to the
same channel.
Connect to APs in Remote Bridge List (Yes/No)
Select Yes to connect to access points in the remote bridge list.
Allow anonymous? (Yes/No)
Select Yes to allow users without accounts to connect.
Note: If Connect to APs in Remote Bridge List and Allow Anonymous are
both set to No, it means that this AP will not connect with other APs and
therefore the AP mode setting will return to AP Only.