Filter
Top Products
3. Utilities
R100 Wireless Gateway 41
Chapter 3 - Software Configuration
DNS Server 1/DNS Server 2 - If you are given instructions from your
ISP to enter DNS addresses, select Yes to manually assign DNSs
and enter the IP addresses here.
PPPoE or PPTP Account
These three items are editable only when WAN Connection Type is
set as PPPoE or PPTP.
User Name - The name of your Internet account provided by your ISP.
Some ISPs work with the entire account name along with the hosting
domain (such as yourname@yourdomain.com) and others require that
you enter only the account name (yourname).
Password - Enter the password for your Internet account.
Idle Disconnect Time in seconds (option) - Enter the number of
seconds of inactivity before you are disconnected from your ISP.
PPPoE MTU - This field is shows the Maximum Transmission Unit
(MTU) of PPPoE packets.
PPPoE MRU - This field is shows the Maximum Receive Unit (MRU)
of PPPoE packets.
Enable PPPoE Relay - Enable PPPoE Relay allows stations in a
LAN to setup individual PPPoE connections that are passed through
NAT. It is also known as PPPoE multi-session.
Special Requirement from ISP
The following two items may be specified by some ISPs. Check with
your ISP and fill them in if required.
Host Name – Fill this in if required by your ISP.
MAC Address – Fill this in if required by your ISP.
Heart-Beat Address – Fill this in if required by your ISP.
LAN IP Setting
IP Address - This is the IP address of the Wireless Gateway as seen
in your local network. The default value is 192.168.1.1.
Subnet Mask - This is the Subnet Mask of the Wireless Gateway as
seen in your local network. The default value is 255.255.255.0.