Filter
Top Products
3. Utilities
R100 Wireless Gateway 67
Chapter 3 - Software Configuration
IP Config in Access Point Mode
Click the IP Config button on the menu to reveal
the submenu. Follow the instructions to setup
the R100 Wireless Gateway. Tips are given when
you move your cursor over each item.
LAN
Get IP Automatically
Select Yes (default) or No to get the IP address automatically from a
DHCP server.
Yes
This parameter determines if the R100 will send out a DHCP request
during bootup. If you have a DHCP server on the network, set this
option so that the R100 can receive an automatic IP address
assignment.
If you have a DHCP (Dynamic Host Configuration Protocol) server on the
network, then the DHCP server will automatically assign the R100 an IP
address when the gateway is powered up. To determine what IP address
has been assigned to the R100, review the IP address on the Status page
available on the Main Menu.
No
The R100 also accepts a static IP address. You may manually configure
the IP address and subnet mask on the IP Config page. Enter an IP
address and a subnet mask in the field provided to assign the R100 a
static IP address. If you don’t know your Gateway setting, leave it
empty (not 0.0.0.0).
Selection items:
• Yes (no info required)
• No (need to input information)
Click Apply or Finish if you make
any changes.