Filter
Top Products
3. Utilities
R100 Wireless Gateway 35
Chapter 3 - Software Configuration
You can set up your wireless environment as shown in this figure:
Remote Bridge List
MAC Address
Enter the MAC address of the target R100 Wireless Gateway in order
to designate which other gateway will be the partner for this gateway.
Note: The content in brackets “( )” is the MAC address in the Remote
Bridge List of the AP. For example, WB1 has the MAC address of WB
in its Remote Bridge List.
In this case, there are six R100s and they are linked as wireless
bridges. Take one of them, named WB, as an example. WB is not in
AP Only mode and Connect to APs in Remote Bridge List is set
as Yes, so it can connect to WB3. Meanwhile, Allow anonymous is
set as Yes or No, but it has the MAC addresses of WB1, WB2, and
WB4 in the Remote Bridge List, so it can be connected to by WB1,
WB2, and WB4.