Filter
Top Products
Troubleshooting
86 R100 Wireless Gateway
Problem
The R100 Wireless Gateway Web Manager still cannot find or connect
to the gateway after verifying the IP address and network cable, changes
cannot be made, or password is lost.
Solution
In the case of the gateway being inaccessible, you can restore the
R100’s factory default settings. Use a straightened paper clip to press
the button located in the hole labeled Reset on the back of the gateway
and keep it depressed over 5 seconds. The LEDs will flash when reset
is successful.
Reset to Defaults
The following are factory default values. These values will be present when
you first receive your R100 Wireless Gateway, if you push the reset button
on the back of the gateway for over 5 seconds, or if you click the Restore
button on the Factory Default page under Advanced Setup.
Name Default Value
User Name admin
Password admin
Enable DHCP Yes
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
DNS Server 1 192.168.1.1
DNS Server 2 (blank)
SSID default
Domain Name (blank)
Appendix -Troubleshooting