Filter
Top Products
SYMBOL SETS/CODE PAGES
C
This appendix contains a listing of the symbol sets, code pages,
and extended character sets the printers support.
Refer to your 9403 Operator’s Handbook or Keypad
Operating Instructions to enter International and
punctuation characters.
Use the charts in this appendix to convert dot sequences from the
image dot pattern to codes you can use in the fields. Use the
Binary to Hex Conversion Chart to convert Binary dot sequences
to Hexadecimal numbers for bitmap files. Use the Dot to Run
Length Encoding Chart to convert dot sequences to alphabetic
characters for bitmap files.
Supported Symbol Sets and Code Pages
The printers support these symbol sets and code pages: Internal,
ANSI, Bold, OCRA Character Set, DOS Code Page 437 and 850.
Additional Code Pages are supported with downloaded TrueType
fonts.
The printer defaults to the internal symbol set. See "Defining the
System Setup Packet" in Chapter 2 to change the symbol set.
Selecting the Internal Symbol Set
Use this symbol set when you want to: use the international
monetary symbols, create formats that may be used on other
MPCLII printers, print the trademark (
) symbol.
The CG Triumvirate fonts and Font 50 support only the ANSI and
DOS Code Page 437 and 850 Symbol Sets. These fonts print a
slashed zero when using the ANSI symbol set. However, the
scalable font does not print a slashed zero.
Symbol Sets/Code Pages
C-1