Filter
Top Products
Configuration Syntax Guidelines
When creating a printer configuration packet:
◆
Follow the "Standard Syntax Guidelines" listed at the
beginning of this chapter.
◆
Begin a packet with the configuration header (
I
).
◆
Download multiple configuration packets within one packet or
download a single configuration packet.
◆
Include the first five ANSI codes, at a minimum, in the control
characters packet.
◆
If you change any of the online configuration packets, resend
the format packet to the printer, so the configuration changes
take effect.
◆
Make sure the communication settings at the host match those
at the printer.
Making Print Adjustments
You can adjust where the printer prints on your supply by
adjusting the supply, print, or margin positions. However, keep in
mind the following:
◆
Supply adjustments across the width of your supply, such as
the margin position, are based in dots- either 203 dpi or 300
dpi, depending on your printhead density.
◆
Supply adjustments for the length of your supply, such as
supply position or print adjustment, are always measured in
1/203 of an inch, regardless of your printhead density.
Defining the System Setup Packet
Use the system setup packet (A) to select the power up mode,
display language, print separators between batches, print a
"slashed zero," and select the symbol set.
2-10
Configuring the Printer