Filter
Top Products
L6. length/
end col
If Using Segments
Column location of end point. Measure
from left edge of print area. Ranges same
as column above. On vertical lines, this
value must match parameter
L4
.
If Using
Vectors
Length of the line in selected units. Use
the previous table for values.
L7. thickness Using the chart below for reference, write the desired line
thickness (
1
to
99
) in box
L7
. Measured in dots.
NOTE:
Line thickness fills upward on horizontal lines, or to
the right on vertical lines.
L8. "pattern" Line pattern. Enter
""
.
Example
L,S,110,30,110,150,10,"" p
Defines a horizontal line field as a segment starting at row 110,
column 30 and ending at row 110, column 150. The line
thickness is 10 dots.
3-28
Defining Fields