Filter
Top Products
Specifying destinations10-30
" If [Admin Settings] - [Security Settings] - [Security Details] - [Restrict
Scan to USB] is set to [Restrict], [USB Memory] is not available. For
details on [Restrict Scan to USB], refer to “[Security Settings]” on
page 3-70.
" With a USB Memory transmission, only one destination can be speci-
fied.
With [HDD]
1 In the initial Scan to Folder mode screen, press [Direct Input].
2 Press [HDD].
3 Press [Save Document].
4 If user authentication settings have been specified, select [Public] or [Pri-
vate].
5 Specify a setting for [Document Name].
6 Press [OK].
" If [Admin Settings] - [Security Settings] - [Security Details] - [Manual
Destination Input] is set to [Restrict], an address cannot be directly
typed in. For details on [Direct Input], refer to “[Security Settings]” on
page 3-70.
" With an HDD transmission, only one destination can be specified.
" Scan data saved on the hard disk can be saved to a computer by
copying it with Web Connection. For details, refer to the [Reference
Guide].
With [Web Service Settings]
With a Web Service transmission, scan data can be sent to a previously reg-
istered network computer.
Network computers where this machine is registered as a Web Service scan-
ner appear as destinations. Select a destination.
1 In the initial Scan to Folder mode screen, press [Direct Input].
2 Press [Web Service Settings].
3 Select the destination.
– If the desired destination is not displayed, press [Search], and then
type in the destination name to be searched for.