Filter
Top Products
104
The Ethernet Bridge page appears.
The appearance of this page varies,
depending on your Gateway’s inter-
faces.
7. If available:
a. Check the Enable Bridging on Port
selection. (This may be Always On.)
b. Click
Submit
.
8. If you want the Gateway to do
both bridging and routing, check
the
Enable Concurrent Bridging/Routing
checkbox.
When this mode is enabled, the Gateway will appear to be a router, but also bridge traf-
fic from the LAN if it has a valid LAN-side address.
9. Check the
Enable System Bridge
checkbox.
The window shrinks.
b. Click
Submit
.
At this point you should be ready to do the final save on
the configuration changes you have made.
The yellow Alert symbol will appear beneath the Help button
on the right-hand end of the menu bar.
10. Click on the Alert symbol and you will see whether
your changes have been validated.