Filter
Top Products
260
• qos – Allows you to specify the Quality of Service for the flow: off, assure, or expedite.
These are used both to mark the IP TOS byte and to distribute packets into the queues
as if they were marked by the source.
SIP Passthrough
set ip sip-passthrough [ on | off ]
Turns Session Initiation Protocol application layer gateway client passthrough on or off.
The default is on.
Session Initiation Protocol, is a signaling protocol for Internet conferencing, telephony,
presence, events notification and instant messaging.
Static Route Settings
A static route identifies a manually configured pathway to a remote network. Unlike
dynamic routes, which are acquired and confirmed periodically from other routers, static
routes do not time out. Consequently, static routes are useful when working with PPP,
since an intermittent PPP link may make maintenance of dynamic routes problematic.
You can configure as many as 32 static IP routes for a Netopia Gateway. Use the following
commands to maintain static routes to the Netopia Gateway routing table:
set ip static-routes destination-network
net_address
Specifies the network address for the static route. Enter a network address in the
net_address
argument in dotted decimal format. The
net_address
argument cannot
be 0.0.0.0.
set ip static-routes destination-network
net_address
netmask
netmask
Specifies the subnet mask for the IP network at the other end of the static route. Enter the
netmask
argument in dotted decimal format. The subnet mask associated with the desti-
nation network must represent the same network class (A, B, or C) or a lower class (such
as a class C subnet mask for class B network number) to be valid.