Filter
Top Products
283
CONFIG Commands
SNMP Notify Type Settings
SNMP Notify Type is supported beginning with Firmware Version 7.4.2.
set snmp notify type [ v1-trap | v2-trap | inform ]
Sets the type of SNMP notifications that the system will generate:
• v1-trap – This selection will generate notifications containing an SNMPv1 Trap Protocol
Data Unit (PDU)
• v2-trap – This selection will generate notifications containing an SNMPv2 Trap PDU
• inform – This selection will generate notifications containing an SNMPv2 InformRe-
quest PDU.
System Settings
You can configure system settings to assign a name to your Netopia Gateway and to spec-
ify what types of messages you want the diagnostic log to record.
set system name
name
Specifies the name of your Netopia Gateway. Each Netopia Gateway is assigned a name as
part of its factory initialization. The default name for a Netopia Gateway consists of the
word “Netopia-3000/XXX” where “XXX” is the serial number of the device; for example,
Netopia-3000/9437188. A system name can be 1 – 255 characters long. Once you have
assigned a name to your Netopia Gateway, you can enter that name in the Address text field
of your browser to open a connection to your Netopia Gateway.
☛ NOTE:
Some broadband cable-oriented Service Providers use the System Name as
an important identification and support parameter. If your Gateway is part of
this type of network, do NOT alter the System Name unless specifically
instructed by your Service Provider.