Filter
Top Products
264
set pinhole name
name
external-port-end [ 0 - 49151 ]
Specifies the last port number in the range being translated.
set pinhole name
name
internal-ip
internal-ip
Specifies the IP address of the internal host to which traffic of the specified type should be
transferred.
set pinhole name name internal-port [ 0 - 65535 ]
Specifies the port number your Netopia Gateway should use when forwarding traffic of the
specified type. Under most circumstances, you would use the same number for the exter-
nal and internal port.
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, port authentication set-
tings, and peer authentication settings for PPP interfaces on your Netopia Gateway.
Configuring Basic PPP Settings.
☛ NOTE:
For the DSL platform you must identify the virtual PPP interface [vccn], a num-
ber from 1 to 8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Netopia Gateway.
set ppp module [vccn] auto-connect { on | off }
Supports manual mode required for some vendors. The default on is not normally
changed. If auto-connect is disabled (off), you must manually start/stop a ppp connection.