Filter
Top Products
254
set ip ethernet A rip-receive { off | v1 | v2 | v1-compat | v2-MD5 }
Specifies whether the Netopia Gateway should use Routing Information Protocol (RIP)
broadcasts to update its routing tables with information received from other routers on
your network.
If you specify v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings
with a maximum of 31 characters, and must match the other router(s) keys for proper oper-
ation of MD5 support.
Default IP Gateway Settings
set ip gateway option { on | off }
Specifies whether the Netopia Gateway should send packets to a default Gateway if it does
not know how to reach the destination host.
set ip gateway interface { ip-address | ppp-vccn }
Specifies how the Netopia Gateway should route information to the default Gateway. If you
select ip-address, you must enter the IP address of a host on a local or remote network.
If you specify ppp, the Netopia unit uses the default gateway being used by the remote
PPP peer.
IP-over-PPP Settings. Use the following commands to configure settings for routing IP
over a virtual PPP interface.
☛ NOTE:
For a DSL platform you must identify the virtual PPP interface [vccn], a num-
ber from 1 to 8.
set ip ip-ppp [
vccn
] option { on | off }
Enables or disables IP routing through the virtual PPP interface. By default, IP routing is
turned on. If you turn off IP routing and save the new configuration, the Netopia Gateway
clears IP routing settings