Filter
Top Products
237
About CONFIG Commands
show dsl
Displays DSL port statistics, such as upstream and downstream connection rates and
noise levels.
show ppp [{ stats | lcp | ipcp }]
Displays information about open PPP links. You can display a subset of the PPP statistics
by including an optional stats, lcp, or ipcp argument for the show ppp command.
start ppp vccn
Opens a PPP link on the specified virtual circuit.
About CONFIG Commands
You reach the configuration mode of the command line interface by typing
configure
(or
any truncation of
configure
, such as
con
or
config
) at the CLI SHELL prompt.
CONFIG Mode Prompt
When you are in CONFIG mode, the CLI prompt consists of the name of the Netopia Gate-
way followed by your current node in the hierarchy and two right angle brackets (>>). For
example, when you enter CONFIG mode (by typing
config
at the SHELL prompt), the
Netopia-3000/9437188 (top)>> prompt reminds you that you are at the top of
the CONFIG hierarchy. If you move to the ip node in the CONFIG hierarchy (by typing ip at
the CONFIG prompt), the prompt changes to Netopia-3000/9437188 (ip)>> to
identify your current location.
Some CLI commands are not available until certain conditions are met. For example, you
must enable IP for an interface before you can enter IP settings for that interface.
Navigating the CONFIG Hierarchy
• Moving from CONFIG to SHELL — You can navigate from anywhere in the CONFIG
hierarchy back to the SHELL level by entering quit at the CONFIG prompt and pressing
RETURN.