Filter
Top Products
7-6 User’s Reference Guide
If the router detected your SPIDs successfully, the screen (as shown on page 7-3) displays them and
indicates “Pass,” meaning that the entered SPIDs initialized. If the SPIDs are entered incorrectly, the fields
will remain blank and the screen will indicate “Fail.” You must then re-enter them manually.
5. U models: Select SPID 1 and enter the primary SPID number. If you did not receive a SPID (AT&T 5ESS
custom point-to-point switches have no SPID), you should skip this and the following step.
Note: SPIDS and DNs may be entered with or without parentheses, commas, or dashes, as you are
accustomed to writing them.
6. U models: If you have a second SPID, select SPID 2 and enter the secondary SPID number.
Note: SPID1 and SPID2 are not displayed for switch types outside North America.
7. If you require a dialing prefix such as “9” to access an outside line on a PBX or Centrex phone system,
select PBX Prefix and enter your dialing prefix. Press Return.
8. Select Data Link Encapsulation and highlight the method of encapsulation that you want to use from the
pop-up menu. The choices offered are PPP, HDLC, or Frame Relay. The default for switched interfaces is
PPP. Press Return.
Note: If you select Frame Relay as your Datalink Encapsulation method, see “Configuring Frame Relay” on
page 7-11 for additional options and detailed instructions.
9. Select NEXT SCREEN and press Return. The “Easy Setup Profile” screen (shown on page 7-7) appears.
Any changes you make to the ISDN configuration now or in the future will take effect immediately. You do not
have to restart the router.
IDSL Easy Setup
The Easy Setup screen for an R3100-I IDSL router is different from the ISDN Easy Setup screen.
ISDN Easy Setup
Circuit Type... IDSL, CMN
+-------------+
+-------------+
Data Link Encapsulation... | Frame Relay |
| ATM FUNI |
+-------------+
TO MAIN MENU NEXT SCREEN