Filter
Top Products
Easy Setup 7-7
Choose your Data Link Encapsulation method. Frame Relay is the default. The choice of Frame relay or ATM
FUNI depends information supplied to you by your DSL service provider.
Easy Setup Profile
The Easy Setup Connection Profile screen is where you configure the parameters that control the ISDN Netopia
Router’s connection to a specific remote destination, usually another network.
1. Select Number to Dial and enter the ISDN telephone number you received from your ISP. This is the
number the Netopia R3100 dials to reach your ISP. Enter the number as you would dial it, including any
required prefixes (such as area, access, and long-distance dialing codes).
If you selected ISDN, Leased, or either of the IDSL options, as your router’s Circuit Type in the ISDN Easy
Setup screen or if you have an IDSL router, Number to Dial will not be an available option. Other
differences include Frame Relay Management Type. For information on Frame Relay Management Type see
“Configuring Frame Relay” on page 7-11. Frame Relay is an alternative datalink encapsulation method for
use over unswitched connections. If this does not apply to your connection, you can skip the corresponding
sections.
2. To enable address translation, toggle Address Translation Enabled to Yes. For more information on
Network Address Translation, see Chapter 11, “IP Setup and Network Address Translation.”
Then select the Local WAN IP Address field. The default address is 0.0.0.0, which allows for dynamic
addressing, your ISP assigning an address each time you connect. However, you may enter another
address if you want to use static addressing.
Note: When using HDLC datalink encapsulation and Network Address Translation, you must use a static
address.
3. If your ISP uses Numbered (Interface-based Routing), select Local WAN IP Address and enter the local
WAN address your ISP gave you.
Connection Profile 1: Easy Setup Profile
Number to Dial:
Address Translation Enabled: Yes
Local WAN IP Address: 0.0.0.0
Remote IP Address: 127.0.0.2
Remote IP Mask: 255.0.0.0
PPP Authentication... PAP
Send User Name:
Send Password:
PREVIOUS SCREEN NEXT SCREEN
Enter the directory number for the remote network connection.
Enter basic information about your WAN connection with this screen.