Filter
Top Products
C9300/C9500 Accessories • 398
3. Hold the hard disk drive by the locking handle (1), then insert the
handle locating lugs (2) and four locating feet (3) into the holes in
the main board making sure the hard disk connector (4) starts to
engage with the socket on the control board.
4. Gently push down on the locking handle (1) making sure the hard
disk moves forward and fully engages with the socket.
5. Replace the main board and secure it with the two screws.
6. Connect the printer interface cable and power cable, then switch
on the printer.
7. Print a MenuMap (see “Printing the MenuMap” on page 33) and
check that the HDD appears at the top of the MenuMap. If it
doesn’t, pull the main board back out and reseat the HDD.
The printer will automatically configure to include this option.
However, you can also set the menu manually as follows:
1. Press the MENU button until
DISK MAINTENANCE is displayed,
then press the SELECT button.
2. When
HDD INITIALIZE is displayed, press the SELECT button.
3. Press the ITEM button to shut down the printer.