Filter
Top Products
C9300/C9500 Software Utilities • 448
Using Overlays
Before overlays can be printed, they must be created in a software
application and saved as a print file, then downloaded to the printer’s
internal hard disk drive or flash memory using Storage Device
Manager.
General Information
To use overlays, the Oki Storage Device Manager software must be
installed. It is recommended that the printer be equipped with the
hard disk drive (standard on all Oki dxn models).
You can save logos, letterheads, etc. as overlays
• on the printer’s internal hard disk drive
(maximum available space, 2 MB each for PCL Macros and
PostScript Forms) or
• in the printer’s flash memory
(available space limited to about 0.5 MB each for PCL Macros
and PostScript Forms)
then add one or any combination of them to a file as it is being
printed.
Use overlays
• in place of pre-printed stationery
• to add your logo or company address to a document
• to create forms from pre-stored modular pieces.
• Overlay elements must be created in the software application
of your choice, then stored on the printer’s hard drive using
Storage Device Manager before they can be used.
• If the hard disk memory is insufficient for the spooled data, the
message DISK FULL appears.
Important!
When the hard disk drive is installed, you must use the Shutdown
Menu before turning the printer off.