Filter
Top Products
39
Troubleshooting
5
5. While pressing down on the green dot
inside the printer, remove the
jammed paper.
6. Reinstall the Star Wheel bar:
a. Insert the pins (➊) in the cradles (➋) at either end and
push the bar firmly down into place.
b. Pivot the bar forward and press in at either end to
reengage the latch tabs.
7. Reinstall the top cover (insert pin in the hole on one side,
then press against the opposite side to slip its pin into the
corresponding hole).
8. Follow steps 5 through 8 under “If the Trailing Edge is Not
Accessible” (see page 37).
➋
➊