Filter
Top Products
Page 5 - 20
Operations
© GBC Films Group January 2001
Orbit™ 2000 Operation and Maintenance Manual
Overlap adjustment
WARNING
WARNING: Only person(s) trained in all aspects of the equipment may
perform any operator adjustments.
WARNING
CAUTION: NEVER TURN THE DIAL ( t ) WHEN THE MACHINE IS STOPPED!
For each paper size, the speed of the feeding head must be adjusted. This is done by manually
turning the dial pointer ( u ) located below the control panel.
Steps
1/ Set the machine to its lowest running speed.
2/ Start the machine.
3/ Set the dial pointer ( u ) to a value
just short of the sheet length. ( ie. a 17 in.
sheet, set the dial to 16.5 in. )
4/ Check the overlap.
5/ Should you require a shorter overlap, turn the dial pointer ( u ) slightly toward the “larger sheet
size” direction.
6/ Should you require a longer overlap, turn the dial pointer ( u ) slightly toward the “shorter sheet
size” direction.
7/ After turning the dial pointer ( u ), always wait for 2 to 4 sheets, before continuing with the
adjustments. The variator has a slight delay.
u