Filter
Top Products
5-32
Upgrades and Options
Installing an Option Board
Note: Before installing an ISA non-plug and play
option board run the SCU and configure the resources
required by the option board.
1.
Power off the system and remove the left side panel
(as viewed from front) as described earlier in this
chapter.
2.
Observe the safety and ESD precautions at the
beginning of this chapter.
3.
Remove and save the expansion slot screw and cover
(Figure 5-12).
Figure 5-12. Removing the Expansion Slot Screw and Cover
A
B
A Expansion slot cover
B Expansion slot screw
Notice: Observe static precautions. Use an antistatic
wrist strap.
4.
Remove the option board from its protective
wrapper, holding the board only by the edges. Do not
touch the board components or the gold connectors.