Packard Bell MH4000 Server User Manual


 
6-20
Problem Solving
Table 6-2. BIOS Messages (Continued)
MESSAGE DESCRIPTION
Press <F1> to resume, <F2> to Setup
Displayed after any recoverable error message.
Press <F2> to enter SETUP
Optional message displayed during POST. Can be turned off
in Setup.
Previous boot incomplete - Default
configuration used
Previous POST did not successfully complete. POST loads
default values and offers to run Setup. If the failure was
caused by incorrect values and they are not corrected, the
next boot will likely fail. On systems with control of wait
states, improper Setup settings can also terminate POST
and cause this error on the next boot. Run Setup and verify
that the wait-state configuration is correct. This error is
cleared the next time the system is booted.
Real time clock error
*
Real time clock fails BIOS test. May require board repair.
Shadow Ram Failed at offset:
nnnn
*
Shadow RAM failed at offset
nnnn
of the 64K block at which
the error was detected.
nnnn
Shadow RAM Passed
Where
nnnn
is the amount of shadow RAM in kilobytes
successfully tested.
System battery is dead - Replace and
run SETUP
The CMOS clock battery indicator shows the battery is dead.
Replace the battery and run Setup to reconfigure the
system.
System BIOS shadowed
The system BIOS is copied to shadow RAM.
System cache error - Cache disabled
*
The RAM cache failed the BIOS test and BIOS has disabled
the cache.
System CMOS checksum bad - run
SETUP
The system CMOS has been corrupted or incorrectly
modified, perhaps by an application program that changes
data stored in CMOS. Run Setup and reconfigure the
system either by getting the default values or making your
own selections.
System RAM failed at offset:
nnnn
*
The system RAM failed at offset
nnnn
of the 64K block at
which the error was detected.
nnnn
System RAM Passed
Where
nnnn
is the amount of system RAM in kilobytes
successfully tested.
System timer error
*
The timer test failed. Requires repair of the system board.
UMB upper limit segment address:
nnnn
Displays the address
nnnn
of the upper limit of the Upper
Memory Blocks, indicating released segments of the BIOS
which may be reclaimed by a virtual memory manager.
Video BIOS shadowed
The video BIOS is successfully copied to shadow RAM.
* If your system displays this message, write down the message and notify your customer
representative. If your system fails after you made changes in the BIOS Setup menus,
you may be able to correct the problem by entering Setup and restoring the original
values.