Filter
Top Products
4-23
Configuring Your System
Table 4-7. Function Select Switch Settings
Switch Signal Settings Function
SW1 RESERVED Off (factory setting)
On
Reserved for future use.
SW2 RSTMASK Off (factory setting)
On
Reset pushbutton switch on front of system is
enabled.
Reset pushbutton switch on front of system is
disabled.
SW3 ACLINK Off (factory setting)
On
Sets server for use with a local power source.
Sets server for use with an optional
uninterruptible power supply (UPS) unit and
disables the Power button on the front of the
server.
SW4 RESERVED Off (factory setting)
On
Reserved for future use.
4.
Set the appropriate switch on or off, according to
Table 4-7.
Note: If you set SW2 to On for use with an optional
UPS unit, power the unit up before switching power
on the server.
5.
Press the main Power switch on.
■
If using an UPS unit, the server powers up as
soon as the UPS unit is turned on (the Power
button on the front of the server is disabled.)
■
If not using the UPS unit, press the Power
button on the front of the server.
Configuring Processor Board Jumper
This section describes how to configure and set the
processor board jumper for the number of CPUs on the
board. Figure 4-2 shows the location of the processor
board jumper.