Filter
Top Products
5-45
Upgrades and Options
5.
Carefully pull out on the thumbscrew until the
middle and the top of the front cover are released,
then remove it from the chassis by pulling it
straight up and out of the hinge tabs at the bottom
edge of the cover.
Figure 5-18. Removing Front Plastic Cover
POWER
STATUS
DISK
POWER
RESET
B
A
C
Removing front plastic cover
from media and diskette drive
bays
A Thumbscrew that secures the
front plastic cover to the front
of the chassis
B Four snap-in tabs that secure
the front plastic cover to the
top and middle of the chassis
C Two frame hinge tabs
6.
Place the frame face down on a soft surface to
prevent marring it.
7.
From the bay where you want to install a drive,
remove the two screws securing the blank panel
tray to the chassis (Figure 5-19).
8.
Grasp the blank panel tray and slide it out of the
bay.
9.
Remove the two screws securing each side rail to
the blank panel tray (Figure 5-20).