Filter
Top Products
4-17
Configuring Your System
Exiting BIOS Setup
To exit Setup, select Exit from the menu bar to display
the Exit Setup menu.
The following table describes the options on this menu.
Note that ESC does not exit this menu. You must select
one of the items from the menu or menu bar to exit this
menu.
SELECTION DESCRIPTION
Save changes and
Exit
Stores the selections displayed in the menus in
CMOS and exits the Setup program.
Exit without Saving
Changes
Exits the program without saving any changes you
have made in this session. Previous selections
remain in effect.
Get Default Values
Displays default values for all Setup menus. Useful
if BIOS detects a problem with the values stored in
CMOS.
Load Previous
Values
Reverts to previously saved values if the new
values have not been saved to CMOS.
Save Changes
Stores the current selections without exiting the
Setup program.
SCSISelect Utility
Your system board includes two integrated SCSI host
controllers used to manage SCSI devices in your
system. The AIC7880 wide SCSI controller provides
support for four internally mounted ultra/wide hard
disk drives. The AIC7860 narrow SCSI controller
provides support for internally mounted tape and CD-
ROM devices as well as externally connected SCSI
devices.
The integrated SCSI host controllers are configured
using the SCSISelect utility. Use the SCSISelect utility
to:
■
Change the SCSI host adapters default values.
■
Check and/or change SCSI device settings for a
particular device.
■
Perform low-level formatting on SCSI disk devices.
■
Perform verify operations on SCSI disk devices.