Filter
Top Products
2. Preparation
20
For assistance, please visit http://www.panasonic.com/consumersupport
2.2 Turning the power
switch ON
Turn the power switch to the ON position (1).
Note:
L When you operate the unit right after turning
the power switch ON or after leaving the unit
unused for a long period of time, the scanner
lamp (2) will flash for a short while. The
scanner will also move instantaneously. This
is normal for the unit. After that, the scanner
lamp will remain ON (the default is for approx.
15 minutes, feature #403 on page 62).
2.3 Dialing mode
If you cannot dial (page 26), change this setting
depending on your telephone line service.
1 Press {MENU}.
SYSTEM SETUP
PRESS [()]
2 Press {#}, then {1}{2}{0}.
DIALING MODE
=TONE [V^]
3 Press {1} or {2} to select the desired setting.
{1} “PULSE”: For rotary pulse dial service.
{2} “TONE” (default): For tone dial service.
4 Press {SET}.
5 Press {MENU} to exit.
1
2
{SET}
{MENU}
FLB851-PFQX2175YA-en.book Page 20 Thursday, September 8, 2005 2:24 PM