Filter
Top Products
8. Programmable Features
64
To transfer a recorded incoming message to
another telephone (page 58), activate this
feature and program the transfer telephone
number.
1. Press {MENU}.
2. Press {#}, then {6}{0}.
3. Press {A} or {B} repeatedly to select “ON”.
4. Press {SET}.
5. Enter the transfer telephone number.
6. Press {SET}.
7. Press {MENU}.
Code #61: Checking, recording or erasing the
transfer greeting message
TRNS-GREETING
CHECK [±]
See page 58 for details.
Code #67: Setting the incoming message
monitor
ICM MONITOR
MODE=ON [±]
To hear an incoming message (ICM) from the
speaker when the answering machine is
recording the message.
“ON” (default): You can monitor the incoming
message.
“OFF”: Deactivates this feature.
Code #70: Calling your pager
PAGER CALL
MODE=OFF [±]
See page 59 for details.
Code #76: Setting the connecting tone
CONNECTING TONE
MODE=ON [±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use those tones to confirm the status of the other
party’s machine.
L If the ring back tone continues, the other
party’s machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
“ON” (default): You will hear connecting tones.
“OFF”: Deactivates this feature.
Code #77: Changing the receiving mode in
the AUTO ANSWER setting
AUTO ANSWER
MODE=TAM/FAX [±]
“TAM/FAX” (default): Telephone Answering
Machine/Fax mode (page 45)
“FAX ONLY”: Fax only mode (page 46)
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO [±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select “YES”.
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
8.4 Direct commands for
programming features
You can also select the desired setting by directly
entering the program code (# and a 2-digit
number) and direct command.
For more details on the features, see page 60 to
page 64.
1 Press {MENU}.
2 Press {#} and the 2-digit code number.
3 Press the desired direct command, using the
dial keypad, to display the desired setting.
L This step may be slightly different
depending on the feature.
4 Press {SET}.
5 To exit programming, press {MENU}.
8.4.1 Program code and direct
command button
{#}{0}{0} Quick Setup
– {1}: “TAM/FAX” (default)
– {2}: “DIST. RING”
– {3}: “TEL ONLY”
– {4}: “FAX ONLY”
L Press {SET} 2 times before pressing the
direct command button.
FPG376.book Page 64 Wednesday, July 30, 2003 6:28 PM