Paradyne 3160-A3 Network Card User Manual


 
C. Configuration Options
3160-A2-GB21-90 February 2001
C-17
Clock Rate: 1544
Next 2048 1544 8 Prev
External Clock Rate. Specifies the clock rate when the master clock source is configured
for external clock (Ext). This configuration option does not appear when the clock source
is not an external clock.
2048
Sets the input rate of the external clock to 2,048 kHz.
1544
Sets the input rate of the external clock to 1,544 kHz.
8
Sets the input rate of the external clock to 8 kHz.
NOTES:
This configuration option is only available on 2-port and 4-port DSU/CSUs.
External clock rate 2,048 kHz does not imply E1 compatibility.
Tst Timeout: Enab
Next Enab Disab Prev
Test Timeout. Specifies whether user-initiated loopback and pattern tests have durations
that are specified by the Tst Duration configuration option.
Enab
Loopback and pattern tests initiated on the DSU/CSU have specified durations.
Disab
Disables test timeout. The tests are terminated manually.
NOTE: For DSU/CSUs that are remotely managed through an inband data stream
such as EDL or FDL, the recommended setting is Enab. If tests are inadvertently left in
the active state, the Enab setting will allow the test to timeout (terminate) after a
specified time.
Tst Duration: 10
Next Up Down Save Prev
Test Duration. Specifies the duration (1 to 120 minutes) of user-initiated loopback and
pattern tests. (The Tst Timeout configuration option must be set to Enab.) Use the left or
right arrow key to position the cursor on the digit you want to change. Use the Function
keys (Up or Down) to increment or decrement the digit.
Up
Increments the test duration.
Down
Decrements the test duration.
Save
Stores the test duration.
Table C-6. General Configuration Options (2 of 2)