Filter
Top Products
3160-A2-GB21-90 February 2001
D
Government Requirements and Equipment Return
Certain governments require that instructions pertaining to CSU and modem connection to the telephone network be
included in the installation and operation manual. Specific instructions are listed in the following sections.
United States
NOTICE TO USERS OF THE UNITED STATES TELEPHONE NETWORK
1. This equipment complies with Part 68 of the FCC rules. On the equipment is a label that contains, among other
information, the FCC registration number and ringer equivalence number (REN) for this equipment. The label is
located on the bottom of the standalone 3160, 3164, or 3165 DSU/CSU, and on the 3161 DSU/CSU’s circuit card.
If requested, this information must be provided to the telephone company.
2. There are two types of telephone lines associated with the standalone equipment. The T1 network connection
should be made using a Universal Service Order Code (USOC) type RJ48C jack. The Service Order Code 6.0F
should be specified to the telephone company when ordering the T1 line. In addition, the proper Facility Interface
Code must be specified to the Telephone Company. The DSU/CSU can be configured to support any of the
following framing format and line signaling techniques. The DSU/CSU’s configuration must correspond to the T1
line’s parameters. The standalone 3160, 3164, or 3165 DSU/CSU’s internal modem connects to the Public
Switched Telephone Network using a USOC Type RJ11C jack. The Facility Interface Code 02LS2 along with the
RJ11C jack should be specified to the telephone company when ordering a dial line for the modem. The
3161 DSU/CSU connects to the T1 network using the multi-line USOC-type RJ48H jack and does not have a
PSTN interface.
3. The ringer equivalence number (REN) is used to determine the quantity of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an
incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to the line, as determined by the total RENs, contact the telephone
company to determine the maximum RENs for the calling area.
4. If the 316x DSU/CSU causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. But if advance notice is not practical, the telephone
company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with
the FCC if you believe it is necessary.
5. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect
the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you
to make the necessary modifications in order to maintain uninterrupted service.
316x DSU/CSU Facility Interface Codes
Code Description
04DU9-BN 1.544 Mbps superframe format (SF) without line power
04DU9-DN 1.544 Mbps SF and B8ZS without line power
04DU9-1KN 1.544 Mbps ANSI ESF without line power
04DU-1SN 1.544 Mbps ANSI ESF and B8ZS without line power