Paradyne 3160-A3 Network Card User Manual


 
C. Configuration Options
C-24
February 2001 3160-A2-GB21-90
CStop Bits: 1
Next 1 1.5 2 Prev
Communication Port Stop Bits. Configures the number of stop bits (1, 1.5, or 2) for the
communication port.
NOTE: This configuration option is not available if the communication port is configured
for synchronous operation.
Ignore DTR: No
Next Yes No Prev
Communication Port Ignore DTR State. Specifies whether the DSU/CSU ignores the state
of the Data Terminal Ready (DTR) input to the communication port.
Yes
DTR is ignored.
No
DTR is not ignored.
NOTE: This configuration option is not available if the communication port is configured
for synchronous operation.
CmInActTm: Disab
Next Enab Disab Prev
Communication Port Inactivity Timeout. Specifies whether the communication port
disconnects after a period of inactivity specified by the CmDiscTm configuration option.
Enab
The communication port disconnects after the period of inactivity specified by the
CmDiscTm configuration option.
Disab
The communication port does not disconnect due to inactivity.
CmDiscTm: 5
Next Up Down Save Prev
Communication Port Disconnect Time. Specifies the period of time (1 to 60 minutes)
before the communication port disconnects due to inactivity. (The CmInActTm
configuration option must be set to Enab.) Use the left or right arrow key to position the
cursor on the digit you want to change. Use the Function keys (Up or Down) to increment
or decrement the digit.
Up
Increments the time delay.
Down
Decrements the time delay.
Save
Stores the time delay for use with inactivity disconnects.
Modem Use: ASCII
Next Mgmt ASCII Term Prev
Modem Port Use. Specifies how the modem port is used.
Mgmt
Configures the modem port as the link to an SNMP or Telnet system.
ASCII
Configures the modem port as a proprietary ASCII port. This selection supports
dial-out ASCII alarm messages and dial-in/dial-out front panel access.
Term
Configures the modem port as the interface to an async terminal.
NOTE: This configuration option is available on
standalone
DSU/CSUs only.
Table C-7. User Interface Configuration Options (7 of 10)