Filter
Top Products
Console Commands 4-23
Using the Network Packet
Use the Network Packet to send console commands directly to the
network card via the printer’s serial port. If the network card does not
appear to be communicating with the printer, you can use the Network
Packet to change the SSID, IP address, etc. of the network card.
Note: You can use Network Packet even if MonarchNet2 is disabled
or not installed. Printer console commands are available but
network console commands are not.
Syntax {N,number,action,device,”name”¦
C,”con_cmds”¦}
N1. N Network Console Packet.
N2. number Number from 0-999 to identify the network
console packet.
N3. action Enter A to add to packet to the printer.
N4. device Enter T to pass the packet through the printer and
stores the packet in the network card.
N5. “name” Packet name, 0-8 characters, enclose within
quotation marks.
C1. C Command field.
C2. “con_comds” Console commands. Must be enclosed within
quotation marks. Each command must be on a
separate line. The maximum number of
characters per command is 100. See the list of
commands earlier in this chapter for more
information.
Note: The maximum number of commands per packet is ten
(10).
Example {N,1,A,T,”mystore”¦
C, ”set ip me static”¦
C, ”init” ¦
C, ”exit” ¦}
Sends the Network Packet 1 “my store” directly to the network card
(T) and sets the IP method to static for determining IP addresses.
Init and Exit commands must be used to save changes and initialize
the network card.