Filter
Top Products
755 Printhead is open. Close the printhead before
continuing. If the error persists, call Technical Support.
756 The printer is out of supplies. Load supplies.
757 Load supplies. The calibrated supply length differs by
plus or minus .25 inches from the format.
758 Check supply. Either the On-Demand sensor is broken,
or the supply is not seen. Adjust the On-Demand sensor
so it is over a white area on the supply, or set the unit to
continuous mode.
762 Low battery. Recharge the battery.
763 Waiting to dispense label. Press the trigger.
765 Printhead failure. You need a new printhead. Call
Technical Support.
770 The print motor is not ready. Call Technical Support.
771 The format specified by the application was not found.
Reload your application and format, and try again. If the
problem continues, call Technical Support.
790 The printer is busy. Turn off the printer. Wait two
seconds and turn it back on. Resend the packets. If the
problem continues, call Technical Support.
791 The printer has an error pending. Turn off the printer.
Wait two seconds and turn it back on. Resend the
packets. If the problem continues, call Technical
Support.
792 The printer is not initialized. Call Technical Support.
793 The printer job queue is full. Turn off the printer. Wait
two seconds and turn it back on. Resend the packets.
If the problem continues, call Technical Support.
Errors numbered 900-999 are hard printer failures. Call Technical
Support if you receive these messages.
Troubleshooting
7-15