Filter
Top Products
Section 4: Ribbon and Print Media 21
Digital Label Press 3 User’s Manual
3. Place the supply end of the ribbon into the supply end of the Ribbon Cartridge
as indicated. Make certain that the ribbon is fed from underneath the supply
end of the ribbon roll, up and over the top of the take-up end of the ribbon roll.
4. Once the ribbon is installed into the Ribbon Cartridge, it can then be placed
into the printer. See Part D of this section for instructions on inserting a loaded
Ribbon Cartridge into the printer.
D. PLACING THE RIBBON CARTRIDGE INTO THE PRINTER
1. Press the Cover Release Button. Allow the cover to swing up and open.
2. With the cover open, place the Ribbon Cartridge into the printer. Be certain that
the supply end of the Ribbon Cartridge is oriented towards the rear of the
printer.
3. Close the cover. When you start to print, the notches on the Ribbon Drive Hub
will automatically engage the take-up end of the ribbon.
NOTE: When the ribbon is installed properly, the black sensing plug in the supply end of the ribbon
roll should be located in the back, left-hand corner of Press's interior. This sensing plug tells
Press which type of ribbon is installed and MUST be present in order for Press to function.
Take-Up End
Supply End
Impressa3.qxd 10/22/01 9:29 PM Page 21