Filter
Top Products
Chapter 3 Downloading Into Flash Memory
122
K2 WRONG FILE
CHECKSUM
The printer detected emulation or file
corruption during download or emulation
bootup.
Re-install the emulation or re-download the
flash files.
K3 DC PROGRAM
NOT VALID
There is no emulation installed or the
emulation in flash memory is corrupted.
Install/re-install emulation software to the
printer.
K4 NO FLASH FILE
SYSTEM
The flash file system is corrupted or the
flash memory is unformatted.
Install/re-install emulation software to the
printer.
K5 DRAM FAIL AT
ADDRESS
xxxxxxxx
Contact your authorized service
representative.
K6 FLASH MEMORY
FAIL
Contact your authorized service
representative.
K7 PROGRAM FLASH
FAIL AT
xxxxxxxx
Contact your authorized service
representative.
K8 FLASH MEMORY
FULL
There is not enough flash memory space for
the emulation or file download.
Initiate the flash file system optimization.
K9 PROGRAM
NEEDS MORE DRAM
Make sure DRAM devices are all detected
by the system.
Contact your authorized service
representative.
L0 INVALID DRAM
CONFIGURATION
Make sure there is a total of 32 MB of
DRAM (two 16 MB DRAM SIMMs) on the
controller board. If so, replace the DRAM, or
replace the controller board.
Table 2. Flash Messages