Filter
Top Products
Paper Control Menu
75
“Tray Width” here is defined as the edge of the paper parallel to the
drum. If the paper tray is set for Letter size or A4 size, the Variable
Tray Width setting in the menus must be greater than the length.
Variable Tray Length
With Variable Tray Length, it is possible to override the standard
cut sheet paper tray lengths. The standard cut sheet paper sizes
are listed in the following table. Using Custom Tray Length and
modified paper trays, it is possible to use non-standard paper stock
that is a different length than standard paper lengths.
You can independently adjust the lower tray length in the menus.
To adjust the width of the bottom tray, select Lower Tray Length
from the Variable Length Tray Length menu. The tray length is
adjustable from 8.3 inches to 19.6 inches, in 0.1 inch increments.
NOTE: The Variable Tray Length feature requires modified paper
trays. Do not change the Variable Tray Length menu
settings unless you are using a modified paper tray.
Also, you cannot modify the length for a standard cut sheet
tray. The length depends on the cassette paper size and is
recognized by the printer using the paper size detector
sensors.
The following table lists the standard settings for the cut
sheet paper tray. (0 = plastic insert; — = no insert)
Paper Size IPS 12/22 IPS 11/21 IPS 10/20
Legal —0 0
Ledger 0 0 —
A3 0 — 0
B4 0 — —
Letter — 0 —
A4 — — 0
Custom Size
(variable width 7.0 - 12.0 inches,
variable length 8.3 - 19.6 inches)
000