Filter
Top Products
Chapter 2 Loading Paper
38
To clear this message, either add paper to the active tray,
or insert a matching tray in the alternate tray position. Then
press CLEAR on the control panel.
Tray linking is disabled by the printer automatically when
the lower tray is configured as a variable length tray, and is
selected as a source tray. Tray linking is resumed after the
lower tray is reconfigured to a standard cut sheet paper
size.
Variable Tray Width
If your printer is equipped with the cut sheet paper feed option, you
can override the standard cut sheet paper tray widths with a feature
called Custom Tray Width. The standard cut sheet paper tray sizes
are listed in the table on page 37. Using Custom Tray Width and
specially-modified paper trays, it is possible to use nonstandard
paper stock that is wider or narrower than the standard paper
widths.
If you are using the Custom Tray Width feature, use the control
panel to adjust the width of the image in the printer to match your
nonstandard width paper.
To set a custom tray width, see Cut Sheet Options on the Paper
Control menu, on page 69.
NOTE: The Custom Tray Width feature requires specially modified
paper trays.
Variable Width is enabled, but the values are resumed after
the lower tray has been reconfigured to standard paper
size.
Paper selection has to be set to the lower tray with a
custom tray inserted in order to make the variable tray
width available through the control panel.