Filter
Top Products
Chapter 2 Powering On The Printer
40
Powering On The Printer
Legend:
1) Power Switch
1. Plug the printer into a 200, 220, or 240 VAC, 30 Amp, 50-60 Hz
power source as shown on the rear panel label. (The DC power
supply must be set for the proper line voltage. Using an
incorrect power source or improperly setting the DC power
supply will damage the printer.)
2. Turn on the printer by setting the power switch to | (on).
3. Note that when you power on the printer, the following occur:
a. The printer reads the emulation and displays the message:
“B0: Printer Boot
Please Wait...”
b. The ONLINE indicator lights continuously and STAND BY
goes out.
1