Filter
Top Products
Paper Control Menu
71
For example, a form length parameter setting of 10 inches
results in a paper length setting of 10 inches, as 10 inches is
within the valid range for form length and paper length
parameters. A form length setting of 24 inches results in a
paper length setting of 12 inches, as 24 is above the valid
range. A form length setting of five inches results in a paper
length setting of 10 inches, as five is below the valid range.
• Inch Select/Length in Inches. This allows you to set the paper
length in inches. The range is 7.0 to 20.0 inches, in one-half
inch increments. The default is 11.0 inches.
• 6 LPI Select/Length at 6LPI. This menu selection allows you to
set the paper length in lines. The range is from 42 to 120 lines,
in 1 line increments. The default is 66 lines.
Paper Selection
Paper selection specifies the type of paper and, for the cut sheet
option, the cassette to be used. You may select fanfold (factory
default) paper, or the upper or lower cassette, which holds various
sizes of cut sheet paper.
Cut Sheet Output
Cut Sheet Output specifies which output tray is used. You may
select the face down (default) or face up orientation. The face down
tray is located on the top of the printer, the face up tray is located
above the optional power stacker.
NOTE: If you select the face up tray, the first page printed is on the
bottom of the stack, and the last page printed is on the top
of the stack.
The Cut Sheet Output menu option is used only if the printer has
the cut sheet paper feed option installed.
Fanfold Output
The Fanfold Output option specifies the paper path through the
stacker. You can select either into the stacker (default) or to bypass
the stacker.