Filter
Top Products
Stacker Operation Keys
43
Stacker Operation Keys
The power paper stacker contains four keys for operating the
elevator:
• AUTO: Sets the elevator in automatic mode. Pressing this key
causes the elevator table to rise until it reaches its maximum
upper position and enables the stacker.
• STOP: Stops the elevator, and displays the message “Stacker
Not Ready” on the printer control panel. The STOP key may be
used to stop the elevator from lowering after pressing the
DOWN key.
• DOWN: Lowers the elevator to its lowest position, or until the
STOP key is pressed.
• HEAVY: ON equals “Heavy Mode” for thicker paper (LED is lit);
OFF equals “Normal Mode” for thinner paper (LED is not lit).
This key is only active in STOP mode and when there is no
paper in the stacker.
When operating the power stacker in Heavy Mode, the maximum
stack height following a cut or page eject depends on the page
length, as shown in the following table:
Page Length (Inches) Max. Stack Height (Inches)
7.0 7.5
7.5 7.2
8.0 7.0
8.5 6.6
9.0 6.4
9.5 6.1
10.0 5.8
10.5 5.5
11.0 5.3