Filter
Top Products
IGP/VGL Submenu
121
Resolution
Cmd Resolution
• Low Res. The default. Sets a low command resolution mode.
• High Res. Sets a high command resolution mode.
^Dnn Dot Slew
• Low Res. The default. Sets the dot slew command dot values to be
interpreted as 60 dpi P-Series dots.
• High Res. Sets the dot slew command dot values to be interpreted as
print engine dots.
Var Ratio Barcd
• Low Res. The default. Sets dot values to be interpreted as 60 dpi P-
Series dots.
• High Res. Sets dot values to be interpreted as print engine dots.
Font Options
The Font Set specifies which language is currently selected for use with the
VGL. Refer to page 123 for available selections.
Uniform Fonts
• Disable. The default. The typeface selected while in Extended Graphics
Mode will be cancelled when the graphics pass is complete.
•Enable. The typeface selected while in Extended Graphics Mode will also
be used in Standard Graphics Mode and Normal Mode.
Proportional Line Length
•Enable. The default. The position of the next graphic element will be
determined by the physical length of a text string (when using a
proportional spaced font).
• Disable. The position of the next graphic element will be determined as if
the font was monospaced (all characters had the same specified width).
PI Control
Printer PI
• Disable. The ASCII emulation is configured with the PI line disabled.
•Enable. The ASCII emulation is configured with the PI line enabled.