Filter
Top Products
202
Appendix A
Media:
Type: Roll-fed, die-cut continuous or fan-fold labels,
tags or tickets; most direct thermal or thermal
transfer materials.
Supply Roll: 8 in. (203 mm) maximum diameter on 3” (76
mm) diameter cores.
7 in. (178 mm) maximum diameter on 1" (25
mm) diameter cores.
Internal Rewinder: Accepts a 5 inch diameter roll of labels or label
backing.
Label Material: Thermal transfer plain-coated papers, vinyl,
Mylar
®
, metallized paper, non-woven fabric, fine
woven fabric, thermal-visible light scannable
paper, infrared scannable paper, thermal ticket/
tag stock, thermally sensitive plastic stock.
Thermal Transfer
Ribbons:
Standard Widths are:
1.00” (25mm)
1.57” (40mm)
2.36” (60mm)
3.15” (80mm)
4.33” (110mm)
Media Sensing: Moveable “see-through” for die-cut labels and
reflective for tags with black striping.
The T4204 printer uses a movable sensor to
detect index holes/notches or the black stripe in
tag stock. The Transmissive sensor position is
indicated by the sensor crystal at the front of the
label guide that is visible with the printhead
open. The Reflective sensor position is located
under the R2, far right side resistor, also visible
with the printhead open. The sensor can be
moved by squeezing the two locking tabs,
located under the label guide, and sliding the
sensor assembly in or out. For proper sensing,
ensure that the sensor is aligned with the center
portion of the index hole/notch or black stripe.
Label Taken Sensor: Detects when a printed label is at the printer exit
throat.
Automatic Label
Peel-Off:
Peels and presents label to the operator, one at
a time.