Filter
Top Products
Fault Messages
197
FILE SYSTEM FULL
Add Flash
Yes Insufficient Flash memory
available to store file.
Contact your authorized service
representative.
FRAMING ERROR Yes Serial framing error.
(serial interface)
Check your serial host interface
parameter settings. If
necessary, change them so
they match the settings of the
attached host.
GAP NOT
DETECTED
Check Media
Yes Printer is set for
Transmissive or
Reflective sensing, but a
gap, notch, or stripe is not
being detected.
Trans Value is set too low
or Refl Value is set to
high.
1. Check to see that the media
installed matches the media
sensor selected in the Config.
menu.
2. Clean the sensor assembly
and paper path.
3. Perform the Run Calibrate
procedure described in this
manual to improve sensors
ability to detect the media in
use.
4. Manually enter a new Trans
of Refl value in the Calibrate
submenu.
LABEL PRESENT
Remove Label (see
note)
Yes 1. This is the normal
message when Peel-off
or Tear-off Media
Handling has been
selected.
2. Label detected at front
of the printer by the
Label Taken Sensor.
Label Taken Sensor
gate is in the down, or
enabled, position.
3. Incorrect media
handling method is
selected.
1. Remove the label from the
front of the printer to allow the
next label to print.
2. Change the Media Handling
selection to the correct
option.
3. Select Tear-off Strip or
Continuous to prevent the
printer from stopping for label
removal after each label is
printed.
Table 13. LCD Message Troubleshooting (continued)
Displayed Message
Can
User
Correct?
Explanation Solution