Filter
Top Products
31
6. Slide a roll of media over the media roll guide and onto the support
assembly. Media feeds from the top of the roll and towards the front of the
printer. Push the roll to the back of the support and slide the roll guide
against the outer edge of the media.
7. Thread the label stock through the label sensor assembly and then
between the platen (drive roller) and the printhead. You can also refer to
the Loading A New Roll or Ribbon illustration label on the inside rear
panel of the printer.
Legend:
1) Roll Guide
2) Media Roll
8. Rotate the media width adjustment tab down and slide it inward until it is
flush with the media. Check the location of the media sensor, and refer to
Sensor Assembly Horizontal Adjustment on page 47.
Legend:
1) Media Width Adjustment Tab
1
2
1