Filter
Top Products
Modifying A Saved Configuration
59
Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel interface instead of the serial interface.
Config. 1: Selects RS-232 Serial Interface
Selects Page Width of 4 inches
Selects Page Length of 24 inches
Selects Image Horizontal Shift of 0.20 inches, etc.
1. Load the configuration to be changed (for example, Config. 1).
a. Press the PAUSE key to take the printer offline.
b. Press the
6 key.
c. Press the6 key.
d. Press the
3 or 4 key to cycle through the options: Factory 1-8.
e. When the desired number displays, press the ENTER key to select it.
The following message is displayed while loading.
Then, the following message displays when it is loaded:
2. Move through the menu and change all the desired values. (In this
example, under Host Interface, you would change the value from Serial to
Centronics.)
3. Press the ENTER key to save each new value. An asterisk (*) displays.
4. Before saving the modified configuration, you must delete the original
configuration if the Protect Configs. option is enabled.
a. Press the
5 key.
OFFLINE
CONFIG. CONTROL
CONFIG. CONTROL
Load Config.
Load Config.
1*
Loading Saved
Configuration
Load Config.
X
*